
rear cable stop
What’s it for?
The Ratio Rear Exit Cable Stop replaces the cable pulley on your SRAM Eagle* derailleur to give it road-style rear exit cable routing. The Cable Stop includes an adjuster so that you can index your gears at the derailleur.
Because you must first remove the cable pulley to fit the Rear Exit Cable Stop, this part is only compatible with Eagle derailleurs that use a bolted cable pulley. On lower-tier models that use a riveted cable pulley, the rivet must be removed with a 4 mm drill bit. This is a dangerous and irreversible process that we do not recommend.
The Rear Exit Cable Stop can also be fitted to older SRAM 1×11 mtb derailleurs for use on frames with road-style cable routing, but be sure to check that the cable pulley is not fitted with a rivet first.


rear exit cable stop compatibility:
- SRAM Eagle* derailleurs from the X01* and XX1* groups
- Pre-fitted SRAM Eagle GX* derailleurs in a Ratio kit bundle
- SRAM 1×11 mtb derailleurs (check that the cable pulley is not riveted)
- SRAM Eagle* derailleurs from the GX*, NX* and SX* groups
*AXS®, DoubleTap®, eTap®, SRAM®,SRAM APEX®, SRAM EAGLE®, SRAM FORCE®, SRAM RED®, SRAM RIVAL®, X0®, X01®, XX1® are registered trade marks owned by SRAM, LLC. Eagle™, Exact Actuation™, GX™, NX™, SRAM APEX 1™, SRAM Force 1™, SRAM RIVAL 1™, S-series™, SX™, WiFLi™, X-Actuation™, XD™, XDR™, XPLR™, XX™, Zero Loss™ are trademarks of SRAM, LLC. The use of these trademarks in the table below is for informative purposes only, and all trademarks remain the property of SRAM, LLC.